Burners

We manufacture gas-fired industrial burners in a wide power range from 9 - 250 kW (31000 - 853000 BTU/h). They are mainly used in industrial thermoprocessing plants for heat treatment and in the heating of metals and non-ferrous metals. They are particularly characterized by an energy-efficient mode of operation using intelligent heat recovery (recuperation). In addition, thanks to their modular design, our burners are very inexpensive to maintain.

Gas control systems

The gas-pressure control, measuring and safety system (GDRMS) is of essential importance for energy-efficient operation of burners. We select the components exactly for the operation of burners and manufacture them in compliance with DIN-EN 762 Part 2 up to a nominal width of DN 150 and a maximum flow rate of 500 standard cubic metres per hour.

Measuring orifices (MB)

Our measuring orifices with nominal width of 25 to 65 are suitable for exact determination of flow rate by means of differential pressure. At the same time, the flow rate can be measured and permanently monitored in combination with a built-in pressure switch according to the requirements of DIN-EN 746 Part 2.

Fans

Combustion-air fans ensure sufficient air supply of burners on a thermos-processing installation. We match them exactly with the operation of selected burners so that they are distinguished by a flat characteristic curve in control mode of operation. An optimal frequency control ensures most favourable operating conditions and, thus, utmost efficiency.

NOXMAT GmbH

We manufacture industrial burners and radiant tubes as well as fittings relating to the heating technology of industrial thermo-processing plants. Our products are sold in over 30 countries around the globe and used in heat treatment plants and facilities for the heating of ferrous and non-ferrous metals.